Toyota — Clutch

POINT OPERATIONS [Point 1 I Removal: Remove the lock ring with pliers Removal: After removing the lock ring, slide the input shaft fully toward the transmission side by using a straight edge screwdriver, etc. Installation: After installing the lock ring, confirm that the input shaft sliding is locked securely by the lock ring. [Point 21 Removal: Service bolts (3 pcs.) Size M8 x 1.25 P= 40 mm Removal - Installation: Turn the flywheel to set to the posi - tion allowing easy installation or removal of the service bolts. Installation: The service bolts always be removed after in - stalling the clutch cover. [Point 31 Inspection: Check the clutch disc for wear. Wear limit (rivet sinking depth):

0.3 mm (0.012 in) Installation: When installing the clutch disc, the longer boss shall face the transmission. Transmission side pln / I I I Dowel [Point 41 Installation: When installing the clutch cover, match the dowel pin holes on the clutch cover flange with dowel pins on the flywheel side. I I I --- I I / / /