REASSEMBLY OF BASIC ENGINE 2.8 Installing speed control lever and governor shaft (1) Insert the governor shaft into the gear case with the governor lever and the tension lever positioned in place. (2) Drive the grooved pin into the gear case. (3) Drive new sealing cap into the gear case. (4) Thoroughly apply Alvania Grease #2 or #3 to the governor shaft cover. (5) Install new O-ring on the speed control lever and insert it into the gear case through the governor shaft. (6) Drive the grooved pin into the gear case. (7) Install the governor spring lever. Note: Install the governor spring lever to the speed control lever with the minimum assembling angle.
Speed control lever Governor shaft cover Tension lever Grooved pin B Governor spring lever Sealing cap Governor lever Grooved pin A Governor shaft Gear case Installing speed control lever and governor shaft Tension lever Governor lever Protrusion approx. 2 mm [0.08 in.] Grooved pin 㧭 Section AA 㧭 Sealing cap Gear case Reassembling speed control lever 2.9 Installing relief valve Insert the relief plunger and relief spring into the gear case, and tighten the plug to the specified torque.
Relief plunger 39.2 to 49.0 N 㨯 m {4.0 to 5.0 kgf 㨯 m} [28.9 to 36.2 lbf 㨯 ft] Plug Relief spring Gear case Installing relief valve 2.10 Installing oil pump Install the oil pump inner gear, oil pump outer gear and oil pump housing to the gear case, and tighten the bolts to the specified torque. Oil pump inner gear Oil pump housing 7.8 to 9.8 N 㨯 m {0.8 to 1.0 kgf 㨯 m} [5.8 to 7.2 lbf 㨯 ft] Oil pump outer gear Gear case Installing oil pump 7-12