REASSEMBLY OF BASIC ENGINE 2.11 Installing PTO gear Install ball bearings on both sides of PTO gear, and install the PTO gear into the gear case. PTO gear Ball bearing Installing PTO gear 2.12 Installing timing gear case (1) Apply sealant to the gasket to prevent it from displacing and install the gasket on the front plate. (2) Apply engine oil to the oil seal lip. (3) Install the timing gear case and tighten the bolts. Bolts on front: 8 pcs. Bolts on rear: 4 pcs. Bolt on rear Bolt on front Installing gear case 2.13 Installing crankshaft pulley Crankshaft pulley &$87,21 The bar could come off. Be very careful.
(1) Screw two guide bolts into the threaded holes at the rear end of the crankshaft. Place a bar across the two guide bolts so that the crankshaft does not turn. (2) Install the woodruff key on the crankshaft. (3) Install the crankshaft pulley and tighten the nuts to the specified torque. 98.1 to 117.7 N 㨯 m {10 to 12 kgf 㨯 m} 72.3 to 86.8 lbf 㨯 ft] Prevent the crankshaft from rotating. Installing crankshaft pulley 7-13