Mitsubishi — 3.3 Installing flywheel

REASSEMBLY OF BASIC ENGINE 3.3 Installing flywheel &$87,21 The person who holds the pulley must be very careful to assure safety by communicating with the person who is installing the flywheel. (1) One person must firmly hold the pulley with a wrench to prevent the crankshaft from turning. (2) Screw the guide bolt into the rear end of the crankshaft. (3) Align the bolt hole of flywheel with the guide bolt and install the flywheel to the crankshaft. (4) Temporarily tighten bolts. (5) Remove the guide bolt and temporarily tighten the last bolt. (6) Tighten the flywheel bolts to the specified torque. Prevent the flywheel from rotating using a wrench.

Detent of flywheel Installing flywheel Tightening torque 83.4 to 93.2N 㨯 m {8.5 to 9.5kgf 㨯 m} [61.5 to 68.7lbf 㨯 ft] Tightening flywheel bolts 7-16 Guide bolt (M10˜1.25 mm)