Mitsubishi — 4.13 Installing torque spring set

REASSEMBLY OF BASIC ENGINE 4.11 Adjusting valve clearance Adjust the valve clearance. For adjusting procedures, refer to "Adjustment and Operation." Adjusting valve clearance Model Ignition order Rotation angle . . q q Mark on gear case side TDC mark on crankshaft pulley side Timing mark 4.12 Installing rocker cover (1) Make sure that the gasket is firmly installed into the rocker cover. (2) Tighten the rocker cover mounting nuts to the specified torque. Tightening torque 4.9 to 6.9 N 㨯 m {0.5 to 0.7 kgf 㨯 m} [3.6 to 5.1 lbf 㨯 ft] Installing rocker cover 4.13 Installing torque spring set For installing procedures of the torque spring set, refer to item "Installing Fuel System." 7-21