Mitsubishi — 4.10 Installing rocker shaft assembly

REASSEMBLY OF BASIC ENGINE 4.9 Reassembling rocker shaft assembly Install the rocker shaft assembly in the reverse order of the disassembly sequence, observing the followings: (1) Apply engine oil to the rocker shaft. (2) Install the rocker shaft assembly in the same position as it was. Note: If the rocker shaft assembly is not installed in the same position, the clearance becomes different, and it may result in a defect such as wear increase. (3) Align oil holes of the rocker shaft with those of the rocker stay, and drive a grooved pin into the front rocker stay. Note: Drive in the grooved pin until it comes into contact with the inside of the rocker shaft.

(4) After reassembling, make sure the rocker arms move freely. Rocker arm Rocker stay Rocker shaft spring Rocker shaft Reassembling rocker shaft assembly Grooved pin Driving in grooved pin 4.10 Installing rocker shaft assembly (1) Install the valve caps to the valve heads. (2) Tighten the long bolts of the rocker bracket to the specified torque. (3) Tighten the short bolts of the rocker bracket. Tightening torque 14.7 to 21.6 N 㨯 m {1.5 to 2.2 kgf 㨯 m} [10.8 to 15.9 lbf 㨯 ft] Installing rocker shaft assembly 7-20