Mitsubishi — 4.8 Inserting push rod

REASSEMBLY OF BASIC ENGINE 4.7 Tightening cylinder head bolts In the numerical order as shown in the illustration, tighten cylinder head bolts progressively to the specified torque.

Cylinder head bolt (main) 73.5 to 83.4N 㨯 m {7.5 to 8.5kgf 㨯 m}[54.2 to 61.5lbf 㨯 ft] Cylinder head bolt (sub) 19.6 to 29.4N 㨯 m {2.0 to 3.0kgf 㨯 m}[14.7 to 21.7lbf 㨯 ft] Tightening order of cylinder head bolts (L2) Cylinder head bolt (main) 73.5 to 83.4 N 㨯 m {7.5 to 8.5 kgf 㨯 m} [54.2 to 61.5 lbf 㨯 ft] 10 11 5 7 6 9 4 8 2 1 3 Cylinder head bolt (sub) 19.6 to 29.4 N 㨯 m {2.0 to 3.0 kgf 㨯 m} [14.7 to 21.7 lbf 㨯 ft] Tightening order of cylinder head bolts (L3) 4.8 Inserting push rod (1) Insert each push rod into its hole in the cylinder head. (2) Make sure that the ball end of each push rod is placed correctly on the tappet cup. Inserting push rods 7-19