FUEL SYSTEM 2.3 Inspecting fuel injection pump on engine Do not disassemble the fuel injection pump unless it is absolutely necessary. If faulty, it is desirable to replace it as an assembly. 2.4 Disassembling and inspecting fuel injection pump Replace: O-ring Fatigue and crack Replace:
Gasket Wear and damage Contact, wear, damage, rust and seizure of plunger Operating condition Fatigue and crack Contact and wear Disassembling and inspecting fuel injection pump Disassembing sequence 1 Swivel nipple 8 Plunger 15 Delivery valve spring 2 Stop wire bracket 9 Plunger spring 16 Delivery valve gasket 3 Control rack 10 Spring upper seat 17 Delivery valve 4 Tappet guide pin 11 Control sleeve 18 Plunger barrel 5 Tappet 12 Lock plates 19 Pump housing 6 Tappet shim plate 13 Delivery valve holder 7 Spring lower seat 14 O-rings 8-12 Inspection item Inspection procedure Judgment Low idling Judgment by rotation speed (Varies depending on specifica tion) Exhaust color Observe exhaust color during sudden acceleration under no load.
Observe exhaust color under load. No remarkable black smooke is emitted. Nozzle injection condition Remove the nozzle and reassemble them so that spray holes face outward. Rotate the starter to carefully observe the spray pattern. The spray pattem must be good.