Mitsubishi — 2.5.1 Installing plunger barrel

FUEL SYSTEM 2.5 Reassembling fuel injection pump 3.2 to 4.0 N 㨯 m {0.3 to 0.4 kgf 㨯 m} [2.2 to 2.9 lbf 㨯 ft] 34.3 to 38.2 N 㨯 m {3.5 to 3.9 kgf 㨯 m} [25.3 to 28.2 lbf 㨯 ft] 4.9 to 6.9 N 㨯 m {0.5 to 0.7 kgf 㨯 m} [3.6 to 5.1 lbf 㨯 ft] 9.8 to 14.7 N 㨯 m {1.0 to 1.5 kgf 㨯 m} [7.2 to 10.8 lbf 㨯 ft] 3.2 to 4.0 N 㨯 m {0.3 to 0.4 kgf 㨯 m} [2.2 to 2.9 lbf 㨯 ft] Reassembling fuel injection pump 2.5.1 Installing plunger barrel Align the plunger barrel groove with the knock pin of the pump housing, and insert the pluger barrel into the pump housing. Note: If the knock pin is not aligned with the plunger barrel groove, the plunger barrel will not be installed correctly.

Make sure that O-ring is not protruded from the pump housing when the delivery valve holder is snugly tightened. Plunger barrel Groove Pump housing Control rack side Knock pin Viewed from above Inserting plunger barrel 8-15