Mitsubishi — 2.5.10 Installing swivel nipple

FUEL SYSTEM 2.5.7 Tightening delivery valve holder (1) Place the pump housing upright, and grab the housing with a vise. (2) Tighten the delivery valve holder to the specified torque. 34.3 to 38.2 N 㨯 m {3.5 to 3.9 kgf 㨯 m} [25.3 to 28.2 lbf 㨯 ft] Delivery valve holder Pump housing Tightening delivery valve holder 2.5.8 Inspecting control rack for smooth opera- tion (1) Remove the pump housing from the vise and check the control rack for smooth movement. If the movement is not smooth, the following defects are suspected: · Sliding of the element is poor. · A foreign substance is present in the teeth of rack or sleeve. · The valve holder is overtightened. (2) Check the injection timing.

Checking sliding of control rack 2.5.9 Installing lock plate (1) Grab the pump housing with a vise. (2) Install the center lock plate first and then side lock plates later. (3) Tighten the screws to the specified torque. Lock plate Screw 3.2 to 4.0 N 㨯 m {0.3 to 0.4 kgf 㨯 m} [2.2 to 2.9 lbf 㨯 ft] Installing lock plate 2.5.10 Installing swivel nipple (1) Install the swivel nipple on the pump housing (2) Tighten the hollow screw to the specified torque. Tightening torque 9.8 to 14.7 N 㨯 m {1.0 to 1.5 kgf 㨯 m} [7.2 to 10.8 lbf 㨯 ft] Swivel nipple Installing swivel nipple 8-18