Mitsubishi — 2.5.6 Installing control rack

FUEL SYSTEM 2.5.5 Installing tappet (1) Install the tappet shim plate. (2) Install the tappet so that its groove is positioned to face the tappet guide pin hole. Groove Tappet Tappet shim plate Tappet guide pin hole (3) Push down the tappet, and install the tappet guide pin. Installing tappet Tappet Tappet guide pin Installing tappet guide pin 2.5.6 Installing control rack (1) Align the control sleeve position so that the protrusion of the control sleeve fits into the fork of the control rack. (2) Install the control rack. Control sleeve Protrusion Fork Control rack (3) Install the stop wire bracket. (4) Tighten the countersunk head screws to the specified torque. Note:

When reusing the countersunk head screws, apply adhesive to the threaded portion. Installing control rack 8-17