FUEL SYSTEM 3.2.1 Installing speed control lever and governor shaft (1) Insert the governor shaft into the gear case while placing the governor lever and the tension lever. (2) Drive the grooved pin A into the gear case. (3) Drive new sealing cap into the gear case. (4) Thoroughly apply Alvania Grease #2 or #3 to the governor shaft cover. (5) With governor shaft cover installed on speed control lever, install a new O-ring on the speed control lever and insert it into the gear case. Speed control lever Governor shaft cover Tension lever Grooved pin B Governor spring lever Sealing cap Governor lever Governor shaft Grooved pin A Gear case (6) Drive the grooved pin B into the gear case.
(7) Install the governor spring lever. Note: Assemble the speed control lever and the governor spring lever with the minimum assembling angle. Installing speed control lever and governor shaft Tension lever Governor lever Grooved pin Protrusion approx. 2 mm [0.08 in.] 㧭 㧭 Section AA Sealing cap Gear case Reassembling speed control lever 3.2.2 Connecting tie rod Connect the tie rod to the control rack of fuel injection pump and fix them with the tie rod clip. Tie rod clip Control rack Connecting tie rod 8-28 Tie rod