Mitsubishi — 2.3 Inspecting oil pressure switch

LUBRICATION SYSTEM 2.2 Inspecting relief valve (1) Check the relief valve and its seat for contact. Check the spring for fatigue and damage. If faulty, replace the relief valve with new one. (2) Measure the relief valve opening pressure. If the pressure does not fall within the standard range, replace the relief valve with new one. Oil pump inner gear Oil pump housing Relief spring Relief valve opening pressure 0.29 ± 0.029 MPa {3.0 ± 0.3 kgf/cmІ} [43 ± 4.3 psi] Oil pump outer gear Gear case Note: Start oil pressure measurement at the engine front side (gear case).

Inspecting relief valve Engine oil pressure measuring port (PT1/8 Engine oil pressure measuring port 2.3 Inspecting oil pressure switch (1) Connect a tester (ohm range) between the terminal and body to check for continuity. The switch is normal if there is continuity between them. If there is no continuity, replace the switch. Check for continuity. ǡ (2) Insert a thin rod from the oil hole and lightly push it. The switch is normal if there is no continuity between them. If there is continuity when the rod is pushed in, replace the switch. (3) When air pressure of 0.05 MPa {0.5 kgf/cmІ} [7.1 psi] is applied from the oil hole and there is no continuity, the switch is normal.

Also check for air leaks. If there are air leaks, the diaphragm is damaged. Replace the switch. Inspecting oil pressure switch (1) Thin rod ǡ Inspecting oil pressure switch (2) 9-6 Item Standard