Mitsubishi — 2.5.7 Installing magnetic switch

ELECTRICAL SYSTEM 2.5.4 Installing yoke and armature (1) Install the planetary gears on the gear shaft. (2) Install the packing on the internal gear. (3) Install the plate and packing. (4) Install the yoke on the front bracket. (5) Apply grease to the armature shaft end and install a ball on it. (6) Install the armature. Note: The adjustment of play in the axial direction of the armature shaft is not necessary. Packing Plate Armature Planetary gear Ball Packing Yoke Installing yoke and armature 2.5.5 Installing brush holder and brush assembly Attach the socket to the commutator of the armature.

While sliding the brushes on the socket, install the brush holder and brush assembly on the armature. Socket Brush holder Brush assembly Installing brush holder and brush assembly 2.5.6 Installing rear bracket Install the rear bracket to the yoke, and tighten the through bolt and the brush holder screws. Screw 2.4 to 4.4 N 㨯 m {0.24 to 0.45 kgf 㨯 m} [2 to 3 lbf 㨯 ft] Rear bracket Through bolt 4.4 to 7.1 N 㨯 m {0.45 to 0.72 kgf 㨯 m} [3 to 5 lbf 㨯 ft] Installing rear bracket 2.5.7 Installing magnetic switch (1) Install the magnetic switch and tighten the screws. (2) Connect the lead to the terminal M and secure it with the fixing nut.

Magnet switch 4.1 to 7.6 N 㨯 m {0.42 to 0.77 kgf 㨯 m} [3 to 6 lbf 㨯 ft] Terminal M 8.8 to 12.7 N 㨯 m {0.90 to 1.30 kgf 㨯 m} [7 to 9 lbf 㨯 ft] Installing magnetic switch 12-21