ELECTRICAL SYSTEM 2.7.7 Removing center bracket Remove the screw, then remove the center bracket. Once the center bracket is removed, the adjusting washer that adjusts the pinion shaft end play can be removed. Center bracket Adjusting washer Screw Removing center bracket 2.7.8 Removing reduction gear and spring set (1) Remove the reduction gear from the pinion shaft. (2) Remove the packing and lever spring from the lever. Lever springs Packing Reduction gear Removing reduction gear and spring set 2.7.9 Removing pinion set (1) Place an appropriate tube on the pinion stopper. Tap the tube with a hammer to drop the pinion stopper to the clutch side. This will expose the stopper ring.
(2) Ply out the stopper ring, and remove the pinion. Note: Do not reuse the stopper ring for reassembly. Appropriate tube Stopper ring Spring Pinion Stopper ring Pinion stopper Removing pinion 2.7.10 Removing lever and pinion shaft Pull out the lever and pinion shaft from the front bracket. Front bracket Pinion shaft Lever Removing lever and pinion shaft 12-29