Mitsubishi — 2.9.1 Applying grease

ELECTRICAL SYSTEM 2.9 Reassembling starter (M002T66071 (24V-3.2kW)) 8.8 to 12.7N 㨯 m {0.90 to 1.90kgf [7 to 14lbf 㨯 ft] 4.1 to 7.6N 㨯 m {0.42 to 0.77kgf 㨯 m} [3 to 6lbf 㨯 ft] Apply Multemp PS2 (Kyodo Yushi made) or the equivalent. Apply Multemp PS2 (Kyodo Yushi made) or the equivalent. 2.2 to 4.4N 㨯 m {0.24 to 0.45kgf 㨯 m} [2 to 3lbf 㨯 ft] 4.4 to 7.1N 㨯 m {0.45 to 0.72kgf 㨯 m} [3 to 5lbf 㨯 ft] Apply Molykote RAG650 (Dow Corning Asia made) or the equivalent. Reassembling starter (M002T66071 (24V-3.2kW)) 2.9.1 Applying grease &$87,21 (a) To avoid mixing of different greases, remove old grease before applying new grease.

(b) Make sure that the starter mounting surface, brushes, commutator and other electric current conducting compo- nents are free from grease. When overhauling the starter, apply grease to sliding surfaces, gears and bearings in the following:

(1) Parts or areas to which Multemp PS2 (Kyodo Yushi made) or the equivalent is applied Plunger surface (a small amount) Sliding area between lever and pinion shaft Lever (at the point of contact with plunger and point of support) Front bearing of armature shaft Shaft sliding area of pinion shaft Rear bearing of armature shaft Pinion gear fitting surface Center bracket bearing Pnion shaft spline (2) Parts to which Molykote AG-650 (Dow Corning Asia made) or the equivalent is applied Gear shaft, gear and internal gear of armature 12-35