Mitsubishi — 2.8.16 Inspecting insulation of magnetic switch (between M terminal and B terminal)

ELECTRICAL SYSTEM 2.8.11 Inspecting overrunning clutch &$87,21 Do not clean the overrunning clutch in wash oil. Make sure that, when attempting to turn the overrunning clutch, it locks in one direction and rotates smoothly in the opposite direction. Inspecting overrunning clutch 2.8.12 Inspecting pinion Check the pinion for wear and damage. If faulty, replace the pinion with a new one. 2.8.13 Inspecting front bracket The ball bearing should rotate smoothly without abnormal noise. If defective, replace the whole front bracket. 2.8.14 Inspecting gears of starter Check gears of the starter for wear or damage. If faulty, replace the starter.

2.8.15 Inspecting continuity of magnetic switch (between M terminal and case) Check that there is continuity between M terminal and case. If no continuity is observed, replace the magnetic switch with a new one. Terminal S Terminal M Terminal B 2.8.16 Inspecting insulation of magnetic switch (between M terminal and B terminal) Check that there is no continuity between M terminal and B terminal. If continuity is observed, replace the magnetic switch with a new one. Checking magnetic switch for continuity 12-34