ADJUSTMENT AND OPERATION 2. Break-in operation After the engine is overhauled, couple the engine to the dynamometer, and run the engine for break-in operation and inspection. 2.3 Break-in operation time The relationship between the load in break-in operation and the operation time is as shown below. 2.1 Starting up (1) Before starting the engine, check the levels of coolant, engine oil and fuel. Bleed air from the fuel and cooling systems. (2) Stop the fuel supply, and crank the engine with the starter for about 10 seconds to lubricate the engine.
(3) Move the control lever slightly in the fuel increase direction (but not to the "full injection" position), and then turn the starter switch key to the [START] position to start the engine. (4) After the engine is started, adjust the control lever to let the engine operate at a minimum no-load speed (low idle speed). (5) Turn the starter switch key to the [OFF] position and make sure that the engine is stopped. 2.2 Inspecting engine condition after starting up During the break-in operation, check the followings. If any abnormality is found, stop the engine, investigate the cause, and take appropriate measures. (1) The oil pressure must be within the specified value.
(2) The coolant temperature must be within the specified Note: The table above is provided solely for reference purpose. Run the engine at appropriate speed and load for the break-in operation of your engine. Be sure to perform break-in operation after overhaul or installation. value. (3) The engine must be free from any leakages such as oil, 2.4 Inspection and adjustment after break-in operation (1) Valve clearance adjustment (2) Ignition timing inspection (3) Exterior bolt and nut tightness check coolant and fuel. Pay special attention to oil leakage from the fitting face of turbocharger lube oil pipe. (4) Check for an abnormal noise. Note:
Knocking noise will disappear as the coolant temperature rises. (5) Check for the color of smoke and odors. 13-10 Break-in operation time Engine speed (min-1) Load Duration (min) 1 Low rotation speed 600 to 900 No-load 5 2 Medium rotation speed 1000 to 1200 No-load 5 3 High rotation speed 1400 to rated speed No-load 10 4 Rated speed 25 % 10 5 50 % 10 6 75 % 30 7 100 % 20