Mitsubishi — 1.1 Before troubleshooting

TROUBLESHOOTING 1. Troubleshooting 1.1 Before troubleshooting &$87,21 (a) For the fuel injection pump, the injection quantity of each cylinder can be measured only with a pump tester. Do not adjust or disassemble the fuel injection pump even during troubleshooting unless absolutely necessary. (b) To inspect the combustion state of each cylinder, loosen the fuel injection pipe of any cylinder to stop injection, and compare the extent of a drop in the engine speed with that of other cylinders (1) Troubles of the diesel engine often occur in combination of various problem causes, and therefore it is often very difficult to determine the defect from a problem phenomenon.

Especially a similar phenomenon occurs in troubles of the fuel injection pump, fuel injection nozzles and compression pressure. It is, therefore, necessary to conduct a careful study to determine the cause. From the reason above, troubleshooting described in this section is summarized as the inspecting order from items which are more likely to cause problems or items easy to inspect in sequence. (2) The diesel engine has the following characteristics from its structure and combustion system. It is necessary to fully understand these characteristics before performing troubleshooting. The engine produces unique combustion noise (diesel knock) in the normal condition.

The engine discharges slight black smoke at heavy load. High compression and high torque cause vibration on a single unit of the engine. Slight hunting is caused during acceleration and deceleration. 14-2