Mitsubishi — 1.2 Basic engine

SERVICE DATA 1. Maintenance service data 1.1 Engine general Table 2-1 Maintenance service data table - Engine general Unit: mm [in.] 1.2 Basic engine Table 2-2 Maintenance service data table - Basic engine(1 / 4) Unit mm [in.] 2-2 Inspection point Nominal Standard Limit Remark Maximum rotation speed (rated rotation speed used as reference) (Varies depending on specification of destination) Adjusted by the governor.

Minimum rotation speed Compression pressure (at 280 min-1) 2.7 MPa {28 kgf/cm²} [398 psi] Not acceptable at or below 2.2 MPa {22 kgf/cm²} [313 psi] When oil and water tempera- tures at 20 to 30 °C [68 to 86 °F] Lubricating oil pressure Rotated speed 0.29 to 0.39 MPa {3 to 4 kgf/cm²} [42.7 to 56.9 psi] Oil temperature at 60 to 70 °C [140 to 158 °F] Low idling 0.10 MPa {1.0kgf/cm²} [14.2 psi] Valve timing Inlet open BTDC 18° Values for checking valve timing Different from actual valve opening and closing timing Inlet open ABDC 46° Exhaust open BBDC 46° Exhaust open ATDC 18° Valve clearance Inlet 0.25 [0.0098] When engine is cold Exhaust 0.25 [0.0098] Fuel injection timing (before TDC) (Varies depending on specification) Inspection point Nominal Standard Limit Remark Rocker arm Rocker arm inside diameter ø 12 [0.47] 12.013 to 12.035 [0.4730 to 0.4738] Rocker shaft outside diameter ø 12 [0.47] 11.470 to 11.984 [0.4516 to 0.4718] Clearance between rocker arm and rocker shaft 0.029 to 0.065 [0.0011 to 0.0026] 0.200 [0.0079] Replace rocker arm Valve Valve stem outside diameter Inlet ø 6.6 [0.260] 6.565 to 6.580 [0.2585 to 0.2591] 6.500 [0.2559] Exhaust ø 6.6 [0.260] 6.530 to 6.550 [0.2571 to 0.2579] 6.500 [0.2559] Valve guide inside diameter Inlet ø6.6 [0.260] 6.600 to 6.615 [0.2598 to 0.2604] Exhaust Clearance between valve stem and valve guide Inlet 0.020 to 0.050 [0.0008 to 0.0020] 0.100 [0.0039] Replace valve and valve guide Exhaust 0.050 to 0.085 [0.0020 to 0.0034] 0.150 [0.0059]