SERVICE DATA Table 2-2 Maintenance service data table - Basic engine(2 / 4) Unit mm [in.] 2-3 Inspection point Nominal Standard Limit Remark Valve seat and valve Valve seat angle 44° Seat width Valve Valve Valve sinkage margin seat angle Valve sinkage 0.5 [0.0197] 0.4 to 0.6 [0.0158 to 0.0236] Valve margin 1.0 [0.0394] 0.5 [0.0197] Valve guide mounting length 14 [0.5516] 13.5 to 14.5 [0.5319 to 0.5516] Valve spring Free length 40 [1.57] 38.5 [1.516] Squareness ǰ θ=2° ٌ Δ=1.4 [0.055] Lf Lf=40 [1.57] Δ=2.0 [0.079] over entire length Mounting length/load 35.5 [1.3976]/55.3 to 61.2 N {5.64 to 6.24 kgf} [12.4 to 13.8 lbf] -15% 28.0 [1.1024]/138.2 to 152.9 N {14.09 to 15.59 kgf} [31.1 to 34.4 lbf] Cylinder Pushrod Runout 0.3 [0.012] or less 0.3 [0.012] TIR, Replace Cylinder head Distortion of cylin- der head bottom surface 0.05 [0.0020] or less 0.10 [0.0039] Repair Distortion of block top surface 0.05 [0.0020] or less 0.10 [0.0039] Repair Cylinder inside diameter L2A, L3A ø 65 [2.56] 65.00 to 65.03 [2.5591 to 2.5602] +0.7 [+0.0276] Repair limit is +0.2 [+0.0079] L2C, L3C ø 70 [2.76] 70.00 to 70.03 [2.7559 to 2.7571] L2E, L3E ø 76 [2.99] 76.00 to 76.03 [2.9921 to 2.9933] Cylindericity 0.01 [0.039] or less