Mitsubishi — 3. Disassembling and inspecting gear case, timing gears and camshaft

DISASSEMBLY OF BASIC ENGINE 3. Disassembling and inspecting gear case, timing gears and camshaft Replace: Gasket Wear of cam contact surface and circumference contact surface Replace: O-ring Replace: Gasket Fatigue and crack Wear and damage of weight Damage and wear Wear and damage of sliding sleeve Wear and damage of sliding shaft contact Rotation condition Replace: O-ring Replace: Gasket Replace: Sealing cap Damage, wear, abnormal key groove Flaking, wear, deformation and key groove wear Fatigue and crack Clogged oil hole Replace:

Gasket Crack, abnormal knock hole, clogged oil hole Wear, damage, aging of lip surface Disassembling and inspecting gear case, timing gears and camshaft Disassembling sequence 1 Tappet 13 Relief spring 25 Camshaft (Remove parts 23 to 25 as a unit) 2 Oil pump cover 14 Relief plunger 3 Gear pump housing 15 Grooved pin 26 Sliding shaft 4 Crankshaft pulley 16 Governor shaft 27 Governor weight 5 Gear case 17 Tension lever 28 Fuel injection pump camshaft gears 6 Ball bearing 18 Governor lever 29 Ball bearing 7 PTO gear 19 Governor spring lever 30 Snap ring 8 Ball bearing (Remove parts 6 to 8 as a unit) 20 Grooved pin 31 Ball bearing 21 Speed control lever 32 Fuel injection pump camshaft (Remove parts 28 to 32 as a unit) 9 Oil pump housing 22 Idler gear 10 Oil pump outer gear 23 Camshaft gear 33 Torque spring set 11 Oil pump inner gear 24 Ball bearing 34 Front plate 12 Plug 5-8