Mitsubishi — 3.4 Removing timing gear case

DISASSEMBLY OF BASIC ENGINE 3.1 Removing tappet Remove the tappet from the cylinder block using the push rods. Note: If the camshaft is removed before the tappet, the tappet will fall in the oil pan. Tappet Pushrod Removing tappet 3.2 Removing gear pump housing (1) Remove the bolts and one stud (M8Ч1.25mm-15mm) shown in the illustration from the gear pump housing. (2) Screw a jack bolt into the stud threaded hole, and remove the gear pump housing. Stud (M8 ˜ 1.25 mm-15 mm) Gear pump housing Bolt Removing gear pump housing 3.3 Removing crankshaft pulley &$87,21 The bar that stops the the crankshaft from turning may come off. Pay due attention to safety.

Crankshaft pulley (1) Screw two guide bolts into the threaded holes at the rear end of the crankshaft. Stick a bar across the guide bolts to prevent the crankshaft from turning. (2) Remove the crankshaft pulley. (3) Take out the woodruff key of the crankshaft. Prevent the crankshaft from rotating. Removing crankshaft pulley 3.4 Removing timing gear case Bolts on front: 8 pcs. Bolts on rear: 4 pcs. &$87,21 The front plate is bolted to the crankcase from inside the gear case. Do not attempt to remove the front plate together with the gear case by tapping. (1) Remove bolts from the timing gear case. (2) Remove the timing gear case. Note: Bolts have different lengths.

Pay attention to the positions of bolts to ensure correct reassembling. Bolt on rear Bolt on front Removing gear case 5-9