Mitsubishi — 3.10 Removing idler gear

DISASSEMBLY OF BASIC ENGINE 3.9 Measuring timing gear backlash Measure the backlash of the timing gears by using one of the following two methods; measure the gear play with the dial gauge plunger applied to a tooth flank on the pitch circle at a right angle to the tooth axis, or measure the clearance between gears by inserting a feeler gauge between the gears at the tooth-to-tooth contacting area. Replace the faulty gear pair if the limit is exceeded. Measuring timing gear backlash 3.10 Removing idler gear (1) Remove the snap ring. (2) Remove the idler gear.

Snap ring Idler gear Removing idler gear 5-11 Item Standard Limit Timing gear backlash Between crank- shaft gear and idler gear 0.010 to 0.136 mm [0.0004 to 0.0054 in.] Spur gear 0.300 mm [0.0118 in.] 0.040 to 0.118 mm [0.0016 to 0.0047 in.] Heli- cal gear Between idler gear and valve camshaft gear Between idler gear and pump camshaft gear 0.010 to 0.136 mm [0.0004 to 0.0054 in.] Spur gear 0.037 to 0.117 mm [0.0015 to 0.0046 in.] Heli- cal gear Between valve camshaft gear and PTO gear 0.010 to 0.220 mm [0.0004 to 0.0087 in.] Spur gear 0.007 to 0.235 mm [0.0003 to 0.0091 in.] Heli- cal gear