DISASSEMBLY OF BASIC ENGINE 4. Disassembling and inspecting cylinder block, crankshaft, piston and oil pan Piston ring wear, damage, end gap Connecting rod bend, twist, big end thrust clearance 13 Flaking, scratches, seizure 7 8 9 Piston wear, sticking, streaks, ring groove wear 10 12 Cylinder flaws, stepped wear 6 5 Flaking, scratches, seizure 11 Top face distortion Replace: Side seal 16 Replace:
Oil pan gasket 2 Plug, dowel pins damage, clogging or contamination of oil/water holes 15 Flaking, scratches, seizure 14 Crankshaft gear teeth damage, sticking to bearing Journal, pin damage, local wear, cracks, bend, clogged oil hole Flaking, scratches, seizure 1 4 3 Disassembling and inspecting cylinder block, crankshaft, piston and oil pan Disassembling sequence 1 Oil pan 7 No.1 compression 12 Main bearing cap 2 Oil screen 8 No.2 compression 13 Lower main bearing 3 Connecting rod cap 9 Oil ring 14 Crankshaft 4 Lower connecting rod bearing 10 Piston (Remove parts 5 to 10 as a unit) 15 Upper main bearing 16 Cylinder block 5 Connecting rod 11 Upper connecting rod bearing 6 Piston pin Note:
When replacing the crankcase, carefully remove parts (relief valve, etc.) mounted on the non-reusable crankcase so that they can be reused. 5-15