Mitsubishi — 4.9 Removing crankshaft

DISASSEMBLY OF BASIC ENGINE 4.7 Measuring crankshaft end play Measure the crankshaft end play (difference between the crankshaft thrust journal width and the width of the bearing cap assembled with thrust plates). Measuring crankshaft end play 4.8 Removing main bearing cap (1) Remove the main bearing cap bolts. (2) Remove the main bearing caps. To remove the main bearing caps of front and rear sides, use a driver as leverage. Place the tip of driver in the oil hole, and remove the cap using the crankshaft balance weight as the fulcrum. Note: (a) Be careful not to damage the main bearings. (b) Mark the main bearings for their cylinder numbers for reassembly.

Removing main bearing cap 4.9 Removing crankshaft &$87,21 Be careful not to damage bearings when removing the crankshaft. (1) Slowly lift the crankshaft straight up. (2) Arrange the bearings in the order of disassembly so that their original positions are restored when reassembling. Note: (a) When raising the crankshaft, do not allow wire chain to come into contact with the crankshaft. To avoid damage to the crankshaft when raising, use a cloth belt or pad. (b) Mark the bearings for their cylinder numbers. Removing crankshaft 5-18 Item Standard Limit Crankshaft end play 0.050 to 0.175 mm [0.0020 to 0.0069 in.] 0.500 mm [0.0197 in.]