INSPECTION AND REPAIR OF BASIC ENGINE 1. Inspecting and repairing cylinder head and valve mechanism 1.1 Measuring clearance between rocker arm and rocker shaft Measure the inside diameter of the rocker arm and outside diameter of the rocker shaft. Replace the rocker arm or rocker shaft if the clearance exceeds the limit. Measuring directions Measuring points Measuring directions Measuring rocker arm inside diameter and rocker shaft outside diameter 1.2 Measuring valve stem outside diameter and valve guide inside diameter Measure the diameter at the top and bottom ends at right angles to the outer and inner surfaces, since valve stems and valve guides are more likely to wear at both ends.
If the outside diameter is less than the limit, or the clearance exceeds the limit, replace either the valve or the valve guide with a new one.
Measuring directions Measuring points Measuring valve stem outside diameter Inside micrometer Measuring directions Measuring points Measuring valve guide inside diameter 6-2 Item Nominal Standard Limit Rocker arm inside diameter ø 12 mm [0.47 in.] 12.013 to 12.035 mm [0.4730 to 0.4738 in.] - Rocker shaft outside diameter ø 12 mm [0.47 in.] 11.470 to 11.984 mm [0.4516 to 0.4718 in.] - Clearance between rocker arm and shaft - 0.029 to 0.065 mm [0.0011 to 0.0026 in.] 0.200 mm [0.0079 in.] Item Nominal Standard Limit Valve stem outside diameter Inlet ø 6.6 mm [0.260 in.] 6.565 to 6.580 mm [0.2585 to 0.2591 in.] 6.500 mm [0.2559 in.] Exhaust ø 6.6 mm [0.260 in.] 6.530 to 6.550 mm [0.2571 to 0.2579 in.] 6.500 mm [0.2559 in.] Clear- ance between valve stem and valve guide Inlet - 0.020 to 0.050 mm [0.0008 to 0.0020 in.] 0.100 mm [0.0039 in.] Exhaust - 0.050 to 0.085 mm [0.0020 to 0.0034 in.] 0.150 mm [0.0059 in.] Valve guide inside diameter Inlet ø 6.6 mm [0.260 in.] 6.600 to 6.615 mm [0.2598 to 0.2604 in.] - Exhaust ø 6.6 mm [0.260 in.]