Mitsubishi — 1.3 Replacing valve guide

INSPECTION AND REPAIR OF BASIC ENGINE 1.3 Replacing valve guide (1) Pull out the valve guide from the bottom to the top face of the cylinder head with a press using a blanking tool. Puller Puller 20 [0.79] 65 [2.56] Ǿ 6 [0.24] Ǿ 10 [0.39] Unit mm [in.] Valve guide (2) Using a stopper, press-fit the new valve guide from the top surface of cylinder head. After press-fitting, make sure the dimensions of valve position are as shown in the illustration. (3) After press-fitting the guide, insert new valve and make sure that it slides. (4) Inspect contact between the valve and valve seat.

Pulling out valve guide 14 r 0.1 [0.55 r ] ( Ǿ 25) [0.98] Ǿ 12.5 [0.492] ( Ǿ 6.6 +0.015 0 ) [0.260 +0.00059 0 ] 14 r 0.5 [0.55 r ] Ǿ 24 [0.94] Stopper Unit mm [in.] Press fitting valve guide 6-3 (Ǿ12) [0.47]