INSPECTION AND REPAIR OF BASIC ENGINE 1.4 Inspecting valve face Apply a thin coat of Shinmyoutan or equivalent lead-free coloring paste on the valve face, and strike the valve face against the valve seat using a valve lapper to check for contact condition. If the contact is not even, or any defects are found, or if the limit is exceeded, reface or replace the valve. Note: (a) Inspect the valve face after the valve guide is repaired or replaced. (b) Do not rotate the valve when pressing the valve face coated with Shinmyoutan or equivalent lead- free dye against the valve seat. (c) Always lap the valve and valve seat after the valve has been refaced or replaced.
Valve lapper Shinmeitan Checking valve face Valve-to-valve seat contact Seat width Valve margin Valve sinkage Valve seat angle Valve-to-valve seat contact position 1.5 Refacing valve face If the valve face is significantly worn out, reface the valve face using a valve refacer. Note: (a) Grind the valve face using the valve refacer at the specified angle. (b) Secure the valve margin width equal to or greater than the limit. If the dimensions after refacing does not meet the specified values, replace the valve with a new one. Valve refacer Set the valve face angle at the specified angle.
Refacing valve face 6-4 Good Bad Contact (must be at face center) Item Standard Limit Valve seat Valve seat angle 44° – Valve sinkage 0.4 to 0.6 mm [0.0158 to 0.0236 in.] Valve margin 1.0 mm [0.0394 in.] 0.5 mm [0.0197 in.]