Mitsubishi — 1.7 Lapping valve and valve seat

INSPECTION AND REPAIR OF BASIC ENGINE 1.6 Measuring perpendicularity and free length of valve spring Measure the perpendicularity and free length of the valve spring. If the limit is exceeded, replace the valve spring with a new one. Spring perpendicularity (gap) Free length Squareness and free length of spring 1.7 Lapping valve and valve seat Always lap the valve against the valve seat after refacing the valve seat or after replacing the valve. (1) Apply a thin coat of lapping compound evenly to the valve face. Note: (a) Do not allow the compound to adhere on the valve stem. (b) Compound spreads more evenly if it is mixed with a small amount of engine oil.

(c) Use medium-grain compound (120 to 150 mesh) for initial lapping, then use fine-grain compound (200 mesh or finer) for finishing. (2) Use a valve lapper for lapping. Strike the valve against the valve seat while rotating the valve little by little. (3) Wash off the compound using diesel fuel. (4) Coat the contact surface of the valve with engine oil, then lap the valve again. (5) Check valve-to-seat contact.

Valve lapper Compound Lapping valve and valve seat 6-5 Item Standard Limit Free length 40 mm [1.57 in.] 38.5 mm [1.516 in.] Perpendicularity θ = 2.0 °or less ǰ Δ (gap) = 1.4 mm ٌ Lf [0.055 in.] or less Lf = 40 mm [1.57 in.] △ = 2.0 mm [0.079 in.] over entire length Set length/set force 35.5 [1.3976] / 55.3 to 61.2 N {5.64 to 6.24 kgf} [12.4 to 13.8 lbf] -15 % 28.0 [1.1024] / 138.2 to 152.9 N {14.09 to 15.59 kgf} [31.1 to 34.4 lbf]