INSPECTION AND REPAIR OF BASIC ENGINE 1.8 Measuring distortion of the bottom surface of the cylinder head Measuring points &$87,21 Refacing of cylinder head should be kept to an abso- lute minimum. Excessive grinding of the cylinder head may result in defects such as defective combustion and stamping (contact between piston and valve). With a straight edge placed on the bottom face of the cylinder head, measure the bottom face distortion using a feeler gauge. If the measurement exceeds the limit, grind the bottom face using a surface grinder. Measuring distortion of the bottom surface of the cylinder head 1.9 Measuring push rod runout Measure the runout of push rod.
If the standard value is exceeded, replace the push rod. Pushrod L Measuring runout of push rod 6-6 Item Standard Limit 0.05 mm [0.0020 in.] Item Standard Limit Remark Push rod runout Less than 0.3 mm [0.012 in.] 0.3 mm [0.012 in.] Total indicated reading (TIR) 1/2L 1/2L 1/2L