INSPECTION AND REPAIR OF BASIC ENGINE 2. Inspecting and repairing flywheel 2.1 Measuring flatness of flywheel Place the flywheel on a surface plate and move a dial gauge on the friction surface of the flywheel to measure the flatness. Grind the friction surface of the flywheel if the limit is exceeded. Measuring flatness of flywheel 2.2 Inspecting ring gear Inspect the ring gear for a missing tooth or worn teeth, and if defects are found, replace the ring gear. 2.3 Replacing ring gear 2.3.1 Removing ring gear (1) Heat the ring gear evenly with an acetylene torch or other appropriate heat source. (2) Remove the ring gear by striking it evenly around the periphery with a hammer through a rod.
Flywheel Ring gear 2.3.2 Installing ring gear (1) Heat the ring gear evenly up to approx. 100°C [212°F] with an appropriate heater. (2) Install the ring gear onto the flywheel with the no-gear- chamfering side facing to the flywheel. Note: Do not heat the ring gear excessively. Removing ring gear 6-7 Item Standard Limit 0.08 mm [0.0031 in.] or less