INSPECTION AND REPAIR OF BASIC ENGINE 3. Inspecting and repairing gear case, timing gear and camshaft 3.1 Measuring timing gear backlash Measure the backlash of the timing gears by using one of the following two methods; measure the gear play with the dial gauge plunger applied to a tooth flank on the pitch circle at a right angle to the tooth axis, or measure the clearance between gears by inserting a feeler gauge between the gears at the tooth-to-tooth contacting area. Replace the faulty gear pair if the limit is exceeded.
Measuring timing gear backlash 3.2 Measuring clearance between idler gear and idler shaft Measure the inside diameter of the idler gear and outside diameter of the idler shaft. Replace the idler gear or idler shaft if the clearance exceeds the limit. Measuring directions Measuring points Measuring idler gear inside diameter and idler shaft outside diameter 3.3 Replacing idler shaft Press-fit the idler shaft into the cylinder block to the dimension in the illustration.
23.3 +0.3 0 mm [0.917 +0.12 0 in.] Replacing idler shaft 6-8 Item Standard Limit Timing gear backlash Between crank- shaft gear and idler gear 0.010 to 0.136 mm [0.0004 to 0.0054 in.] Spur gear 0.040 to 0.118 mm [0.0016 to 0.0047 in.] Heli- cal gear Between idler gear and valve camshaft gear Between idler gear and pump camshaft gear 0.010 to 0.136 mm [0.0004 to 0.0054 in.] Spur gear 0.037 to 0.117 mm [0.0015 to 0.0046 in.] Heli- cal gear Between valve camshaft gear and PTO gear 0.010 to 0.220 mm [0.0004 to 0.0087 in.] Spur gear 0.007 to 0.235 mm [0.0003 to 0.0091 in.] Heli- cal gear Item Standard Limit Clearance between idler gear and idler shaft 0.030 to 0.066 mm [0.0012 to 0.0026 in.] 0.200 mm [0.0079 in.]