INSPECTION AND REPAIR OF BASIC ENGINE 3.4 Measuring clearance between camshaft journal and cylinder block bore Calculate the clearance between the outside diameter of the camshaft journal and inside diameter of the cylinder block bore. Replace the camshaft or cylinder block if the clearance exceeds the limit. Note: Start measurement from the No.2 camshaft hole because the No.1 camshaft hole is for ball bearings. Measuring points Measuring directions Measuring outside diameter of camshaft journal Measuring inside diameter of cylinder block camshaft holes 3.5 Measuring cam lift Measure the minor and major axes of cam to determine cam lobe lift.
If the lift is less than the limit, replace the camshaft with a new one. Measuring points Measuring directions Measuring cam height of camshaft 3.6 Measuring cam height of fuel injection pump camshaft Measure the cam height. Replace the camshaft if the height is less than the limit. Measuring points Measuring directions Measuring cam height of fuel injection pump camshaft 6-9 Item Standard Limit 0.050 to 0.100 mm [0.0020 to 0.0039 in.] Item Standard Limit 27.27 to 27.47 mm [1.0736 to 1.0815 in.] Item Standard Limit Cam height of fuel injection pump camshaft (longer diameter) 29.9 to 30.1 mm [1.177 to 1.185 in.] 29 mm [1.1417 in.]