Mitsubishi — 3.8 Measuring clearance between tappet and tappet guide hole

INSPECTION AND REPAIR OF BASIC ENGINE 3.7 Inspecting tappet Inspect the cam contact surface of the tappets. Fit new tappets if the surface is excessively worn or damaged. Good Bad Bad Inspecting tappets 3.8 Measuring clearance between tappet and tappet guide hole Measure clearance between the tappet and tappet hole. Replace the tappet with a new one if the limit is exceeded. Measuring directions Measuring directions Measuring clearance between tappet and tappet guide hole 6-10 Item Standard Limit 0.007 to 0.049 mm [0.0003 to 0.0019 in.]