INSPECTION AND REPAIR OF BASIC ENGINE 4.2 Reboring cylinder Cylinders shall be rebored according to the following procedure. 4.2.1 Measuring piston outside diameter Using a micrometer, measure the piston outside diameter at the skirt perpendicular to the piston pins as shown in the illustration.
Direction at right angles to piston pin Measuring positions Measuring piston outside diameter 4.2.2 Boring finish dimension = [piston diameter] + [clearance] - [honing allowance (0.02 mm [0.0008 in.])] 6-12 Item Nominal Standard L2A L3A STD ø 65 mm [2.559 in.] 64.919 to 64.939 mm [2.5559 to 2.5566 in.] 0.25 OS ø 65.25 mm [2.569 in.] 65.169 to 65.189 mm [2.5657 to 2.5665 in.] 0.50 OS ø 65.50 mm [2.579 in.] 65.419 to 65.439 mm [2.5755 to 2.5763 in.] L2C L3C STD ø 70 mm [2.756 in.] 69.913 to 69.933 mm [2.7525 to 2.7533 in.] 0.25 OS ø 70.25 mm [2.766 in.] 70.163 to 70.183 mm [2.7623 to 2.7631 in.] 0.50 OS ø 70.50 mm [2.776 in.] 70.413 to 70.433 mm [2.7722 to 2.7729 in.] L2E L3E STD ø 76 mm [2.992 in.] 75.906 to 75.926 mm [2.9884 to 2.9892 in.] 0.25 OS ø 76.25 mm [3.002 in.] 75.156 to 76.176 mm [2.9983 to 2.9990 in.] 0.50 OS ø 76.50 mm [3.012 in.] 76.406 to 76.426 mm [3.0081 to 3.0089 in.] Item Standard Limit Remark Clearance (clearance between piston and cylinder) L2A, L3A 0.061 to 0.111 mm [0.0024 to 0.0044 in.] 0.2 mm [0.0079 in.] Repair to oversize or replace L2C, L3C 0.067 to 0.117 mm [0.0026 to 0.0046 in.] L2E, L3E 0.074 to 0.124 mm [0.0029 to 0.0049 in.]