INSPECTION AND REPAIR OF BASIC ENGINE 4.3 Measuring piston ring end gap &$87,21 (a) When replacing rings without boring (honing), measure the end gap at the bottom of the cylinder where the wear is minimum. (b) When replacing the ring, use the ring of the same Piston Cylinder size as the piston. Insert the piston ring into the cylinder bore and push it with the piston to achieve squareness. Then measure the end gap with feeler gauges. Replace the piston ring if the limit is exceeded. Measuring piston ring end gap Ring 4.4 Measuring clearance between piston ring groove and piston ring &$87,21 Remove carbon deposits from pistons and check the entire circumference of the piston.
(1) Remove deposits such as carbon from each ring groove. (2) Check each ring groove for wear or damage. If it is worn or damaged, replace the piston with a new one. (3) Insert the piston ring into the piston ring groove. Apply a straight edge and insert thickness gauges to measure the clearance between ring and ring groove. If the limit is exceeded, replace the piston ring with a new one. (4) When the piston ring has been replaced, measure the clearance again, and if the limit is exceeded, then replace the piston with a new one.
Measuring piston ring groove 6-13 Item Standard Limit End gap of ring No.1 com- pression ring 0.15 to 0.30 mm [0.0059 to 0.0118 in] 1.5 mm [0.0591 in.] No.2 com- pression ring 0.15 to 0.30 mm [0.0059 to 0.0118 in] Oil ring 0.15 to 0.35 mm [0.0059 to 0.0138 in.] Item Standard Limit Clearance between ring and ring groove No.1 compres- sion ring - 0.3 mm [0.0118 in.] No.2 compres- sion ring 0.05 to 0.09 mm [0.0020 to 0.0035 in.] 0.2 mm [0.0079 in.] Oil ring 0.03 to 0.07 mm [0.0019 to 0.0028 in.] 0.2 mm [0.0079 in.]