Mitsubishi — 4.6 Measuring connecting rod end play

INSPECTION AND REPAIR OF BASIC ENGINE 4.5 Measuring piston pin bore diameter and piston pin outside diameter Measure the piston pin bore diameter and piston pin outside diameter. Replace if the limit is exceeded. Measuring points Measuring directions Measuring piston pin bore and piston pin outside diameter 4.6 Measuring connecting rod end play (1) Install the connecting rods onto the respective crankpins and tighten the connecting rod cap bolts to the specified torque. (2) Measure the clearance to the crank arm (end play) at Tightening torque: 31.4 to 34.3 N 㨯 m {3.2 to 3.5 kgf 㨯 m} [23.15 to 25.32 lbf 㨯 ft] two positions (above and below the crankpin).

(3) If the limit is exceeded, replace the connecting rod with a new one. Thickness gauge Measuring end play of connecting rod 6-14 Item Nominal Standard Limit Outside diameter of piston pin L2A,L3A L2C,L3C ø 18 mm [0.71 in.] 18.001 to 18.007 mm [0.7087 to 0.7089 in.] - L2E,L3E ø 21 mm [0.83 in.] 21.002 to 21.005 mm [0.8269 to 0.8270 in.] - Clearance between piston pin bore and piston pin outside diameter L2A,L3A L2C,L3C - 0.006 to 0.018 mm [0.0002 to 0.0007 in.] 0.08 mm [0.0031 in.] L2E,L3E - 0.007 to 0.015 mm [0.0003 to 0.0006 in.] Item Standard Limit Connecting rod end play 0.10 to 0.35 mm [0.0039 to 0.0138 in.] 0.50 mm [0.0197 in.]