Mitsubishi — 4.7 Inspecting connecting rod bend and twist

INSPECTION AND REPAIR OF BASIC ENGINE 4.7 Inspecting connecting rod bend and twist (1) Measure the dimensions of C and L in the illustration to check bend and twist of the connecting rod. Straighten the connecting rod with a press to meet the standard. If the standard is exceeded after correction, replace the connecting rod with a new one. (2) In general, a connecting rod aligner is used to check bend and twist. Note: Before checking bend, tighten the connecting rod cap to the specified torque. (3) To inspect the connecting rod with the piston installed, turn the piston upside down and place it on a surface plate.

Insert a round bar having the same diameter as the crankpin into the big-end bore, and measure the height of the bar using a dial gauge. C 100 3.94 0.05 0.0020 L [ ] C 100 3.94 0.05 0.0020 L [ ] C L L Piston pin C Connecting rod bend Connecting rod twist Unit: mm [in.] Inspecting connecting rod bend and twist Tightening torque of connecting rod cap 31.4 to 34.3 N 㨯 m {3.2 to 3.5 kgf 㨯 m} [23.1 to 25.3 lbf 㨯 ft] Measurement with connecting rod aligner D Unit: mm [in.] C D C 100 0.05 3.94 0.0020 [ ] A B Measuring bend of connecting rod 6-15 Item Standard Limit 0.05/100 mm [0.0020/3.94 in.] or less