Mitsubishi — 4.8 Measuring clearance between connecting rod bearing and crankpin

INSPECTION AND REPAIR OF BASIC ENGINE 4.8 Measuring clearance between connecting rod bearing and crankpin Measuring directions Measuring points Tightening torque 31.4 to 34.3 N 㨯 m {3.2 to 3.5 kgf 㨯 m} [23.1 to 25.3 lbf 㨯 ft] &$87,21 When grinding crank pins, be sure to grind all the pins to the same size. Finish the fillet radius to the specified dimension. (1) Reassemble the bearing into the big end of the connecting rod. (2) Tighten the connecting rod cap bolts to the specified torque. (3) Measure the inside diameter of the connecting rod bearing. (4) Measure the outside diameter of the crank pin.

(5) Calculate the clearance from the difference between the inside diameter of the connecting rod bearing and outside diameter of the crank pin. (6) Replace the connecting rod bearing if the clearance exceeds the limit. (7) Measure the clearance between the connecting rod bearing and the crank pin again. Use the undersize bearing if the limit is exceeded. (8) If an undersize bearing is used, grind the crank pin to the specified undersize.

Measuring inside diameter of connecting rod bearing Measuring directions Measuring points Measuring crank pin outside diameter R2 0 -0.2 mm [0.08 0 -0.008 in.] Finish dimension of fillet radius 6-16 Item Nominal Standard Limit Crankpin outside diameter (STD) ø 40 mm [1.57 in.] 39.965 to 39.980 mm [1.5734 to1.5740 in.] -0.70 mm [-0.0276 in.] Clearance between crankpin and connecting rod bearing - 0.028 to 0.071 mm [0.0011 to 0.0028 in.] 0.150 mm [0.0059 in.] Undersize grinding dimensions of crankshaft Item Undersize Finish dimension Crankpin undersize 0.25 mm [0.0098 in.] ø 39.75 -- 00 .. 00 32 50 mm [1.5650 -- 00 .. 00 00 10 48 in.] 0.50 mm [0.0197 in.] ø 39.50 -- 00 ..

00 32 50 mm [1.5551 -- 00 .. 00 00 10 48 in.]