INSPECTION AND REPAIR OF BASIC ENGINE 4.9 Measuring clearance between main bear- ing and crankshaft journal Tightening torque 49.0 to 53.9 N 㨯 m {5.0 to 5.5 kgf 㨯 m} [36.2 to 39.8 lbf 㨯 ft] &$87,21 (a) When grinding crank journals, be sure to grind all the journals to the same size. (b) Finish the fillet radius to the specified dimension. (1) Reassemble main bearings. (2) Tighten the main bearing caps to the specified torque. (3) Measure the inside diameter of the main bearings. (4) Measure the outside diameter of the crank journal. (5) Calculate the clearance between the inside diameter of the main bearing and outside diameter of the crank journal.
(6) Replace the main bearing if the clearance exceeds the limit. (7) Measure the clearance between the main bearing cap and the crank journal again. Use the undersize bearing if the limit is exceeded. (8) If an undersize bearing is used, grind the crank journal to the specified undersize.
Measuring directions Measuring points Measuring main bearing fitting bore Measuring directions Measuring points Measuring crank journal outside diameter R2 0 -0.2 mm [0.08 0 -0.008 in.] R2 0 -0.2 mm [0.08 0 -0.008 in.] Finish dimension of fillet radius 6-17 Item Nominal Standard Limit Outside diameter of crankshaft journal (STD) ø 43 mm [1.69 in.] 42.965 to 42.980 mm [1.6915 to 1.6921 in.] – Clearance between main bearing and crankshaft journal – 0.030 to 0.075 mm [0.0012 to 0.0030 in.] 0.10 mm [0.0039 in.] Undersize grinding dimensions of crankshaft Item Undersize Finish dimension Crank journal undersize 0.25 mm [0.0098 in.] ø 42.75 -- 00 .. 00 32 50 mm [1.6831 -- 00 ..
00 00 10 48 in.] 0.50 mm [0.0197 in.] ø 42.50 -- 00 .. 00 32 50 mm [1.6732 -- 00 .. 00 00 10 48 in.]