INSPECTION AND REPAIR OF BASIC ENGINE 4.10 Measuring crankshaft runout Support the crankshaft at the front and rear journals with V- blocks, and measure the crankshaft runout at the center journal using a dial gauge. If the runout deviates from the standard only slightly, grind the crankshaft to repair. If the runout exceeds the standard considerably, straighten the crankshaft using a press. If the limit is exceeded, replace the crankshaft. If the crankshaft has been repaired by grinding or pressing, inspect the crankshaft for cracks and other harmful damage using a magnetic particle method.
Measuring bend of crankshaft 4.11 Replacing crankshaft gear 4.11.1 Removing crankshaft gear Using a gear puller, remove the gear from the crankshaft. Note: Do not strike the gear with a hammer. Gear puller Removing crankshaft gear 4.11.2 Installing crankshaft gear (1) Install the key on the crankshaft. (2) Press-fit the gear fully in alignment with the key. Aligning position Installing crankshaft gear 6-18 Item Standard Remark Crankshaft runout 0.06 mm [0.0024 in.] TIR