INSPECTION AND REPAIR OF BASIC ENGINE 4.12 Measuring distortion cylinder block top surface Measuring points and directions &$87,21 Refacing of cylinder head should be kept to an abso- lute minimum. Excessive grinding of the cylinder head may result in defects such as defective combustion and stamping (contact between piston and valve). Apply a straight edge to the top surface of the cylinder block and measure its distortion using a feeler gauge. If the distortion exceeds the limit, grind the cylinder block using a surface grinder. Measuring crankcase top surface distortion 6-19 Item Standard Limit 0.05 mm [0.0020 in.] or less