REASSEMBLY OF BASIC ENGINE 1. Reassembling cylinder block, crankshaft, piston and oil pan 1.1 Installing main bearing (1) Install the main bearings (upper and lower) with aligning lug groove of the crankcase and main bearing cap. Note: Install the bearing (upper) with groove to the crankcase, and install the bearing (lower) without groove to the main bearing cap. (2) Install the flange main bearing to the rearmost crankcase mating surface. (3) Apply a small amount of engine oil to each bearing. Installing main bearing 1.2 Installing crankshaft (1) Wash the crankshaft thoroughly with cleaning oil and dry it completely by compressed air. Note:
When washing the crankshaft, clean the inside of the oil holes completely and make sure that no foreign substances or dirt is present. (2) Hold the crankshaft horizontally and slowly install it to the cylinder block. (3) Apply a small quantity of engine oil to the crankshaft journals. Installing crankshaft 7-2