REASSEMBLY OF BASIC ENGINE 1.3 Installing main bearing cap &$87,21 The foremost and rearmost caps should be installed so that they are flush with the cylinder block surface. (1) Apply sealant to the mating surface of the foremost and rearmost caps and the cylinder block mating faces before installing the main bearing caps. Front Sealant or lubricant THREEBOND 1212 or 1211 (2) Install the main bearing caps so that their front marks (arrow) and cap numbers are in numerical order from the front of the engine. (3) Temporarily tighten bolts.
Reassembled position of main bearing cap Flush Installing main bearing cap 1.4 Inserting side seal (1) Apply a sealant to the outer periphery of new side seals. Side seal Sealant THREEBOND 1212 or 1211 (2) With the round section of the side seals facing outward, press them partway into the front and rear caps using hands. (3) When the side seals are installed partway into caps, use a tool with flat surface such as flat-head screwdriver to install completely, taking care not to bend them. Round portion Round portion Installed direction of side seal Inserting side seal 7-3