Mitsubishi — 1.7 Reassembling piston and connecting rod

REASSEMBLY OF BASIC ENGINE 1.7 Reassembling piston and connecting rod (1) With the identification mark of connecting rod facing upward, place the rod on the piston pin setting tool. Connecting rod Identification mark Piston pin setting tool P/N: 30L91-00030 for L2A, L3A ޓޓ 30L91-00020 for L2C, L3C ޓޓ 30L91-10010 for L2E, L3E (2) Set the piston pin push rod and guide to the piston pin. Reassembling piston and connecting rod (1) Pushrod Piston pin Guide ޓޓޓޓޓޓޓޓ Stamped identification mark 㨯 Pushrod D18: For Ǿ 18 mm [0.71 in.] piston pin D21:

For Ǿ 21 mm [0.83 in.] piston pin 㨯 Guide LE D21 :L2E 㨮 L3E For Ǿ 18 mm [0.83 in.] piston pin LCE D18:L2C 㨮 L3C For Ǿ 18 mm [0.71 in.] piston pin L ޓ A ޓ :L2A 㨮 L3A For Ǿ 18 mm [0.71 in.] piston pin Reassembling piston and connecting rod (2) (3) Reassemble the piston to the connecting rod with the front mark ( Δ ) on the piston top and the identification mark of the connecting rod facing upward. Install the piston pin from the piston pin guide. Identification mark Pushrod Piston pin Connecting rod Front mark Guide (4) Press-in the piston pin with the push rod using hydraulic press (pin press-in load 9807±4903 N {1000±500 kgf} [2205±1102 lbf]) until the guide contacts the piston setting tool.

(5) After reassembling, make sure that the piston and the connecting rod move lightly on the piston pin. Reassembling piston and connecting rod (3) Reassembling piston and connecting rod (4) 7-5