REASSEMBLY OF BASIC ENGINE 1.8 Installing piston &$87,21 Every piston ring has a top mark such as “R” near the end gap. Install all piston rings with this mark facing upward. If the rings are installed upside down, it could cause malfunctions such as excessive oil consumption or an engine seizing. T Top face mark No.1 compression ring No.2 compression ring (1) Install the piston rings to the piston with a ring expander. (2) Install the oil ring with its end gap 180° away from the joint of the coil spring, as shown in the illustration.
Reassembling pistons and piston rings Oil ring Coil spring butted ends 180° Oil ring abutment Oil ring end gap/coil spring joint orientation 1.9 Installing piston and connecting rod &$87,21 Do not forcefully insert the piston, as it may cause damage to the piston rings and crank pin. Oil ring end gap No.1 ring end gap (1) Apply engine oil to the circumference of the piston and piston rings. (2) Place the ring end gaps in diagonal positions avoiding the piston pin direction and its right angle direction. (3) Fit the connecting rod bearing (upper) to the connecting rod aligning the lug and lug groove.
(4) Turn the crankshaft to place the crank pin of the assembling cylinder to the top dead center. (5) Face the front mark (arrow) stamped on the piston top toward the timing gear case side (forward of the engine). (6) Insert the piston from the top face of cylinder block using a piston guide (commercially available). Front Oil ring spring joint No.2 ring end gap Orienting piston ring end gaps Installing pistons and connecting rods 7-6