Mitsubishi — 1.10 Installing connecting rod cap

REASSEMBLY OF BASIC ENGINE 1.10 Installing connecting rod cap (1) When the big end of the connecting rod comes into close contact with the crank pin, turn the crankshaft 180° while pressing the piston head. (2) Fit the connecting rod bearing (lower) to the rod cap with the lug aligned with the lug groove. (3) Install the cap to the connecting rod, aligning the mating marks made during disassembly. Note: For new connecting rod on which there is no mating mark, orient the lugs of upper and lower bearings on the same side as shown in the illustration. (4) Tighten the connecting rod cap nuts evenly and progressively to the specified torque. Lug groove Cylinder No.

Installing connecting rod caps Tightening torque 31.4 to 34.3 N 㨯 m {3.2 to 3.5 kgf 㨯 m} [23.1 to 25.3 lbf 㨯 ft] (5) Inspect end play of the connecting rod. If end play is small, loosen and retighten the cap nuts. Tightening connecting rod cap nuts Measuring end play of connecting rod 7-7 Item Standard Limit 0.10 to 0.35 mm [0.0039 to 0.0138 in.]