Komatsu — CONTROL LEVERS AND PEDALS

. OPERATION EXPLANATION OF COMPONENTS When operating the shift lever, be sure to set it in position securely. If the lever is not placed in position properly, the shift position display on the panel may go out and the Transmission system caution lamp may light up. Before shifting between forward and reverse, stop the machine completely and then run the engine at low idle. When starting the engine, if the shift lever is not at the N (neutral) position, the engine will not start.

When the starting switch is at the ON position, if the shift lever is not at the N (neutral) position, the shift lever position pilot lamp will flash, the central warning lamp will light up, and the alarm buzzer will sound. If the parking brake is applied or the shift lever is not at the N (neutral) position, the central warning lamp will light up and the alarm buzzer will sound. If the shift lever is set to any position other than N (neutral) when the dump lever is at a position other than FLOAT or the body is still raised, the central warning lamp will light up and the alarm buzzer will sound. The shift lever must not be returned to the N (neutral) position while traveling.

Release the accelerator pedal and run the engine at low idle when moving the shift lever from the N position to the forward or reverse position. 3 - 43 5 - 1 p osition These positions are u sed in places where it is difficu lt to tr avel at high speed, or when traveling on soft ground, or when startin g the machin e off on a s lope when it is l oaded . They are a lso use when going downhill i f it is needed t o use the b raking forc e of t he engine. While the du mp body is ra ised, t he t ransmission is fi xed to the 1st gea r and is not changed.

Keep the dump body lowered during t ravel REMARK In conformity with the EU safety rule (EN474-6 5.1.3) , the gear shi ft lever is restricted t o the 1st speed and cannot be shifted if i t is anywhere between 1 to 5 positions, when the machine is running while the dump body is not fully lowered to it s seat. The spee d ranges for e ach positi on are as f ollows Position Speed range Max.

speed [km/h (MPH)] R2 R2nd torque converter - direct 17.0 (10.6) R1 R1st torque converter - direct 7.2 (4.5) D 2nd torque converter - 6th direct 57.1 (35.5) 5 1st torque converter - 5th direct 38.6 (24.0) 4 1st torque converter - 4th direct 25.4 (15.8) 3 1st torque converter - 3rd direct 16.5 (10.3) 2 1st torque converter - 2nd direct 10.7 (6.6) 1 1st torque converter - 1st direct 7.0 (4.3)