. OPERATION EXPLANATION OF COMPONENTS OPERATION EXPLANATION OF COMPONENTS When moving the shift lever from the N position to the R1 or R2 DUMP LEVER CAUTION To prevent damage to the dump body through vibration from the road surface, always lower the dump body before traveling. This lever (4) is used to operate the dump body. (a) RAISE (b) HOLD: The dump body stops and is held in position. (c) FLOAT: The dump body moves freely under external force. (d) LOWER Always set to the FLOAT position when traveling.
3 - 44 position or from the D position to position 5, press the lock button on the shift lever before opera Activating the shift hold functi on will restrict the automatic shifting of the transmission to gear sp eeds below the gearshift lever gear shifting. The shift hold function can be canceled by [1] moving the gearshift lever or [2] activating the shift hold switch located on the gearshift lever. The shift hold pilot lamp locat ed on the machine instrument panel will indicated the status of the shift hold function.
r down a range, pre-select the Before starting either up o transmission gear and mainta in a machine travel speed which will give you full control under all t he anticipated conditions. It is impossible to travel in rev erse if the dump body is raised. If the engine stops during the dump operation, the dump body is held in p osition, re gardless of the p osition o f the dump lever. Even when the engine starts again, the dump body is h eld in position. For d etai ls of the method of )". he meth canceling the hold function, s ee "CANCELING DUMP BODY HOLD CONDITION ( PAGE 3-88